www.lewmar.com PART NO. DESCRIPTION 82000356 Rod End AHFT10 Stainless Steel 82000357 Rod End AHFT12 Stainless Steel PART NO. DESCRIPTION 89000006-*** stop ring cobra PART NO. DESCRIPTION LENGTH ONE END LOOSE SYSTEM TYPE mm in 89500011 Draglink Assemblies AHFT 10 1000 40 Cruising 89500012 Draglink Assemblies AHFT 10 2000 80 Cruising 89500013 Draglink Assemblies AHFT 12 1000 40 Racing and Ocean 89500014 Draglink Assemblies AHFT 12 2000 80 Racing and Ocean PART NO. CAN BE MACHINED TO BORE SIZE DESCRIPTION mm in 89500002 80 3 Tiller Lever 89500005 100 4 Tiller Lever 89500008 125 5 Tiller Lever Pin Size Working Centers Bore Size Keyway Angle Keyway Width Keyway Depth Stop Rings Cobra™ Spares and Accessories Limiting the amount of rudder travel is essential on all steering arrangements. The Cobra™ system provides an alternative and simpler to install device than conventional rudder stops – the stop ring. The stop ring, mounted directly below the pedestal, ensures that the output lever travel does not exceed the designed limit. Stops should operate adjacent to operating centres. Note: Additional rudder stop can be fitted to tiller lever if a stop ring cannot be installed. Rod Ends Rods ends can be purchased separate from draglink assemblies as spare parts. Draglinks The draglinks specified above are supplied with one end fitting loose to enable the tube to be cut to size and welded. If the correct centres for the draglink are known contact your Lewmar dealer prior to order for the part number relating to the centre required. Tiller Levers All above part numbers are for standard tiller levers supplied pilot bored at 25mm. Lewmar offer a machining service to supply the tiller lever ready to suit the rudder stock of the boat, please contact your Lewmar distributor for part number and price prior to ordering. Lewmar also offers extended versions to enable the fitting of linear drive type autopilots at 250mm/10" and 350mm/13" centres, in conjunction with the standard 203mm/8" position for the steering draglink. *Customer must specify limiter angle Draglink complete with rod end Rod Ends
RkJQdWJsaXNoZXIy MjM2MTk=